-
Mounting Hardware for Magnet-Actuated Proxmity Switch - Telemecanique
-
GO Switch Hardware Kit 1/4-20 x 1-1/2in Length - Stainless Steel for Magnets
-
Eaton Operator Button - 10250TB63 - Emergency-Stop Red Button Push/Pull Cap Size; 30.5 MM - Used on 2/3 Position Non Illuminated Push Pull Switch; 10250T Model
-
Magnet-Actuated Proximity Switch, Magnet only - Telemecanique *This part replaces old part #20011659
-
Eaton Stop Switch Button (E-Stop) - E22LP2 - Operation Type; Maintained - Glassed Filled Nylon Body - Chrome Plated Brass Bezel - Red Mushroom 40 MM Diameter - Used on Motor Control Panel Door.
-
Suttner - 200005431 - Replacement Reed Switch Only for ST-6 Model
-
Low Level Water and Fill Switch - Prevents pump cavitation by shutting it off due to low water level in tank - 24in wire lead - 1/2in x 1/2in NPT
-
Eaton Padlockable Transparent Cover - E22BA9 - Used on Selector Switches on Sonny's Motor Control Center.
-
Threaded Rod - 1/2-20 x 6in - 50F600SFT0Z - Zinc Plated Steel - Used on Sonny's conveyor ( Go Switch Plate ) Rod Fine Thread - Attaches to Heco shaft - Pack of 5
-
Floor Switch Aluminum Ramp Edging -Set of 2 with hardware - Recora
-
Rotary Switch - 2 Stack, 8-position switch with stops for 2 to 8 positions / limited rotation - Rated at 10A-600VAC continuous - Shallco
-
GO Switch Aluminum Round Disk with hardware. Holds up to 4 magnets
-
Honeywell Low Air Pressure Switch 4PSI for MacNeil RG440 Conveyor ( 44- 128-00-PP )
-
Proximity Reed Switch D-A53L for MacNeil RG440 Conveyor (90-150-01-PP) Lead 18in
-
Pur-Clean Replacement Part - RCC85SA - High Voltage Cable for Ozone Cells - One of these will be needed for each ozone cell.
-
Suttner ST-5 Flow Switch - 200005500 - Temperature - 176 F - Pressure - 4000 PSI - Flow Rate - 8GPM - Inlet - 3/8in FNPT - Outlet - 3/8in FNPT - Voltage -250 - Amps -3.0
-
Proximity Reed Switch D-B54 for MacNeil RG440 Conveyor (44-554-07-PP) Lead 18in
-
General Pump - 100975 - TMT Reed less Flow Switch - GPM 12.0 - Max 5000 PSI - Max Temperature 180° F - Inlet - 3/8in FNPT - Outlet - 3/8in FNPT - 5 amp, Micro Switch - 250 Volts - 48in Cord - Material - Brass -
-
Eaton Selector Switch - M22M-WRK3 - for Motor Control Center - Non- Illuminated - Contact Configuration; 1-Normally Open - 1-Normally Closed
-
Suttner ST-6 Flow Switch - 200006540 - Temperature - 176 F - Pressure - 4500 PSI - Flow Rate - 8GPM - Inlet - 3/8in MNPT - Outlet - 3/8in MNPT - Voltage - 250 - Amps - 3.0
-
Rotary Switch - 3 Stack, 8-position switch with stops for 2 to 8 positions / limited rotation - Rated at 10A-600VAC continuous - Shallco
-
Eaton Contact Block - 10250T1 - 1 Normally Open / 1 Normally Closed
-
Square D Limit Switch Lever Arm Rod 9007FA1 for C54B2 - Arm Length: 10in - Rod Material: Stainless Steel
-
Power Pack - Low Level Oil Switch - Brass Stem, Plastic Float - Switch Normally Closed - Max. operating voltage 115V
-
Magnet-Actuated Proximity Limit Switch - Ideal for frequent actuation - Senses magnetic field and sees through non-magnetic materials - 1/2in NPT conduit - Telemecanique
-
Eaton Button M22-PVT-K01 Twist-to-Release Red Push-Button Switch 1 NC Contact Block, Non-Illuminated