Taper Lock Split Bushing – 1-1/2in Bore – with Intergral Key – Used on
All Sonny’s Mitters Pitman Arms.
Bushing 119257 1-1/2in Taper Lock
Description
Taper-Lock w/Intregal Key
- 1-1/2in
- Used on all Sonny’s mitters
Pitman Arm Installation Instructions for Taper-Lock
1. Clean shaft, bore and outside of bushing, and hub bore of all oil, paint and dirt. File away any burrs.
2. Insert bushing in hub. Match the hole pattern, not threaded holes (each hole will be threaded on one side only).
3. “LIGHTLY” oil set screws and thread into those half-threaded holes indicated by (a) on Figure 2.
4. Alternately torque set screws to recommended torque setting (16 FT. LBS)
5. To increase gripping force hammer face of bushing using drift or sleeve. (Do Not Hit Bushing Directly With Hammer) Re-torque Screws After Hammering.
6. Recheck screw torque after initial run-in, and periodically thereafter. Repeat steps 4 & 5 if loose.
Note: Do Not Use Worn Hex Key Wrenches
To Remove Bushing:
1. Remove all set screws.
2. Insert set screw in hole indicated by (b) on Figure 2. Loosen bushing by tightening set screw.
3. To reinstall, complete all six (6) installation steps.
Type | Bushings |
Feature | Taper Lock Bushing |
Dimension | 1 1/2 in |
Used-On |
SONNY’S Mitters FTB 236/901 Half-Moon Basket STS 807 Flat Basket STS 805/804 Half-Moon Basket |